Owners Manual
Table Of Contents
- 1 Sicherheit und Umwelt
- 2 Beschreibung
- 3 Anschluss
- 4 Anwendung
- 5 Fehlerbehebung
- 6 Reinigung
- 7 Technische Daten
- 1 Safety and environment
- 2 Description
- 3 Interfacing
- 4 Use
- 5 Troubleshooting
- 6 Cleaning
- 7 Technical data
- 1 Sécurité et environnement
- 2 Description
- 3 Raccordement
- 4 Application
- 5 Résolution des erreurs
- 6 Nettoyage
- 7 Spécifications techniques
- 1 Seguridad y medio ambiente
- 2 Descripción
- 3 Conexión
- 4 Utilización
- 5 Subsanación de errores
- 6 Limpieza
- 7 Datos técnicos
C411
III
MANUALC411
III
MANUAL30 31
TROUBLESHOOTINg cLEANINg
5 Troubleshooting
Problem Possible cause Remedy
No sound Power to mixer and/or amplier
is off.
Switch power to mixer or amplier
on.
Channel or master fader on
mixer or volume control on
amplier is at zero.
Set channel or master fader
on mixer or volume control on
amplier to desired level.
Pickup is not connected to mixer
or amplier.
Connect pickup to mixer or
amplier.
Cable connectors are seated
loosely.
Check cable connectors for
secure seat.
Cable is defective. Check cable and replace if
damaged.
No supply voltage. Switch phantom power on.
Phantom power supply: connect
to power outlet or insert battery
(batteries). Check cable and
replace if damaged.
Distortions Gain control on the mixer set
too high.
Turn gain control down CCW.
Mixer input sensitivity too high. Connect a 10 dB preattenuation
pad between pickup cable and
input.
6 Cleaning
Use a soft cloth moistened with water to clean the surface of the
microphone body.