User's Manual

24 P820
Description
Rear Panel
Figure 2: Controls, inputs, and outputs on the Remote Control Unit rear panel
E POWER switch: Turns power to the unit ON (position "I") and OFF (position
"0"). The front panel POWER LED is lit while power is ON and goes out when
you turn power to the unit OFF.
F AC input: Standard IEC power receptacle with integrated fuse holder.
NOTE
To avoid damage, use replacement fuses of the same type and rating
(125 mA/250 V, slow-blow) only.
G Power voltage selector: Sets the input power voltage to 210 - 240 VAC
("210-240V" position) or 110 - 120 VAC ("110-120V" position).
NOTE
To avoid damage, always make sure that the power voltage selector is set to the
same voltage as the power voltage available where you are going to use the unit.
H INPUT: 7-pin female XLR connector for connecting the dedicated
audio/control cable for the microphone.
I OUTPUT: This balanced 3-pin XLR connector provides the microphone
output signal.
J GROUND LIFT: This pushbutton switch allows you to remove hum caused
by ground loops.
To open the chassis ground connection, press the GROUND LIFT button
OUT ("LIFT" position).
To restore the chassis ground connection, press the GROUND LIFT button
IN ("GROUND" position).