User's Manual

3 Setting Up

• If you wish to mount the receiver on the camera in a different position (e.g., further up

front or to the rear):

1. Unscrew the fixing screw (4)and remove the adapter from the mounting plate (6).

2. Use the fixing screw (4) to fix the adapter (5) in the desired position on the mounting plate

(6).

3. Remove the belt clip (1) from the receiver.

4. Place the hot-shoe adapter (2) on the receiver rear panel.

5. Use the belt clip (1) to secure the receiver on the hot-shoe adapter (2).

6. Slide the hot-shoe adapter carrying the receiver into the camera's hot shoe.

7. Tighten the fixing screw (3) on the hot-shoe adapter to secure the receiver on the cam-

era.

To mount the receiver on smooth surfaces, we recommend using commercial auto-adhesive

Velcro fastener.

1. Peel the protective film off a length of velcro tape.

2. Press the tape firmly against the desired spot on the backing surface.

3. Peel the protective film off another length of velcro tape and press the tape firmly against

the receiver rear panel.

4. Press the receiver against the tape on the backing surface, slowly moving the receiver

back and forth to engage the hooks and loops on the tapes.

1. Use the supplied cable with a 2.5-mm TS jack plug (1) on one end and XLR connector

(2) on the other end to connect the LINE OUT jack on the receiver to the desired line-

level input on your camera or recording device.

To connect the receiver to a camera with a 1/8" input jack, use the connecting cable with

a 2.5 mm TS jack and 1/8" TS jack that is also included with the PR4500.2.

If you are going to use headphones, connect them to the HP OUT jack on the receiver.

3. Set the headphone volume as desired.

• To prevent hum interference, do not connect any cable longer than 10 feet (3 m) to the

LINE OUT jack!

• The volume setting affects the headphone output level only and does not affect the

LINE output.

• The LINE OUT level is not adjustable.

To get optimum results, set the input gain on your transmitter and camera as recom-

mended in the respective instruction manuals.

Alternative positions:

Refer to fig. 7.

Velcro Fastener

Connecting

to ENG Equipment

Refer to fig. 8.



Note

BDA-PR4500-120307-Kern:Layout 1 05.06.2012 11:26 Uhr Seite 29