User Guide

to 8 separate mixers can be configured with the AS16x12. If an input is assigned to “None”, it will neither affect any other
channel’s automatic gain or be affected by another channel.
Short Cuts: A left mouse click on the NOM box will associate the input with NOM bus 1, while a right mouse click will
set the association to “None”.
On LED - Indicates that the attenuation applied to the input as a result of the automatic mixing action is less than 6dB. For
inputs in the Direct mode, or inputs whose NOM assignment is “None”, this LED is always lit. Level Meter - Indicates
the inputs level, taking into consideration the Input Gain, and the front and rear panel gain contributions.
INPUT TONE TAB
The Input Tone tab allows the low cut
frequency and the high frequency cut or
boost to be set for each of the 16 input
channels.
Low Cut - Sets the low cut corner
frequency for each input channel. The
low cut filter is a 6dB/octave (i.e. single
pole) filter. Frequency choices are 75Hz,
90Hz, 110Hz, 130Hz, 190Hz, 280Hz,
600Hz, and Flat.
Short Cut: A left click on the low cut box
causes the frequency to be set to “Flat”.
Hi Cut/Boost - Sets the high frequency
cut or boost for each input channel. The
inflection point of the high frequency tone
control is approximately 1kHz. Choices
for cut/boost are -8dB, -6dB, -3dB, Flat,
+3dB, +6dB, and +8dB.
Short Cut: A left click on the hi cut/boost
box causes the cut/ boost value to be set
to “Flat”.
14