Setup guide

44 DMM 6
Installation and Connection
Mount the DMM 6 in your 19" rack.
NOTE
We recommend only using AKG accessory cables for cascading.
The unit has two 100 MBit/s ethernet interfaces. These communicate the control data and
audio between up to 10 units. This allows an automix system with up to 60 input channels, 20
output channels and 10 stereo headphone outputs to be established.
The master buses for "OUT", "REC-OUT" and "HEADPHONE" are accessible for all of the
cascaded units across the entire system. Every unit adds its input channels to the master
buses, which are transferred via the ethernet interface. Every unit can monitor and output the
master buses.
The automix algorithm also transfers its control data via this interface. This allows the automix
algorithm to function system-wide.
The individual units must be connected to the expansion connectors as follows:
Figure 13: daisy-chaining multiple units
ATTENTION
Do not connect the first cascade unit with the last unit.
3 Installation and Connection
Rack mounting
Cascading