Setup guide

DMM 6 45
Installation and Connection
For the user, the function and behaviour of all the units are the same. All of the cascaded units
retain their individual functions. A standard CAT5+ connection cable can be used.
The available "SYSTEM CONTROL" functions associated with cascading are described in the
section Cascaded device operation.
NOTE
Before connecting, read the operating instructions for your microphones and accessories.
Connect microphones and accessories to the back of the DMM 6:
1) Connect microphones and other signal sources (e.g. wireless microphone receivers) to
the "IN" input channels.
2) Connect the "OUT - L" and "OUT - R" output channels to a mixing desk or amplifier.
3) Connect the RCA jacks on the stereo recording output "REC (OUT)" to a recording device.
ATTENTION
Do not connect the unit to the mains power supply until you have established all the audio
connections!
1) Connect the mains power supply cable to the appropriate socket on the rear panel of the
DMM 6.
2) Plug the power supply cable into a mains socket.
Connecting microphones and accessories
Mains connection