Installation Guide

PACKING LIST

Optional accessories

After you open this package, please check to ensure that all of the following

items are included.

IMPORTANT NOTICES: For easy installation, please read all the instruction completely before

beginning. Before installing this product, make sure that water line trash is cleared to avoid

blockage.

A- Faucet B- Mounting Nut + Washer (2)

C- Pop-up assembly(

Optional accessories)

D- Allen Wrench

CAUTION: Maintenance

1. Replacement parts may be available at the store where you purchased your faucet.

2. Always turn off water and relieve pressure before working on your faucet.

NOTES: Cleaning Instructions

1. To keep the faucet clean, you should clean the faucet frequently and regularly.

2. Clean the faucet with clear water or mild liquid, rinse the faucet with clear water and

then dry the faucet with soft cotton cloths.

3. Do not use any abrasive cleansers, cloths, or paper towel.4. Do not use any acid or

abrasive detergent.

Basin Faucet / Vessel Faucet

Model: 40118

40118A1

Questions, problems, missing parts?

call Akicon Customer Service 8 a.m.-6p.m. EST, Monday-Friday

Phone: +1（302）213 4406, Email: service@akiconshop.com

AKICONSHOP.COM

EX: E001001T Rev:A

PAGE 1
Model: 40118 40118A1 CAUTION: Maintenance 1. Replacement parts may be available at the store where you purchased your faucet. 2. Always turn off water and relieve pressure before working on your faucet. NOTES: Cleaning Instructions 1. To keep the faucet clean, you should clean the faucet frequently and regularly. 2. Clean the faucet with clear water or mild liquid, rinse the faucet with clear water and then dry the faucet with soft cotton cloths. 3. Do not use any abrasive cleansers, cloths, or paper towel.
PAGE 2
INSTALLATION PROCEDURES 1. Turn Off Water Supply 2. Install Faucet 2-1 1 5. Cartridge Function 4-2 5 Open Close Hot Press stopper to keep or release water. You should clean all the dirts from valve outlets. Turning off the water supply valves. This is usually found near the water meter. If you are replacing an existing faucet, remove the faucet from the sink and clean the sink surface thoroughly. Lift the handle up, the cartridge will be activated allowing water to flow.