Installation Guide

3
After installation is complete, remove Spray head
and rotate handle to the close position. Turn
Water Supply Valves on, and check all connections
for leak. Flush faucet by running hot and cold
water in full position for one minute.
Replace Spray head.
Open the valve, then turn the handle according to the
sign of C and H on the handle to regulate the temperature
of the water. (C=Cold,H=Hot)
Attach Weights to the pull-out hose using screws at the
proper point of the hose. Be noted Weights are optional.
Turn off water and relieve pressure! Detach handle button
using a small flathead screwdriver, unscrew set screw
using Allen Wrench and take off handle.
Remove handles. Unscrew Dome Cap counter clockwise
by hand. Unscrew Retaining Nut using adjustable wrench,
take out cartridge assembly and inspect. Replace parts
as necessary. Reassemble parts by reversing steps.
5
7
6
8
Handle Removal Maintenance Valve Cartridge Removal Maintenance
Close
Open
INSTALLATION PROCEDURES
You should clean all the dirts from valve outlets.
Turning off the water supply valves. This is usually
found near the water meter. If you are replacing
an existing faucet, remove the faucet from the
sink and clean the sink surface thoroughly.
Install without Deck Plate. Make sure the O-RING
is placed onto the bottom of Base Ring. Install
faucet through hole in sink. From underside sink,
put Plastic Washer and Mounting Nut. Position
faucet on sink properly and tighten Mounting Nut.
Install with deck plate. Place a bead of plumbe r’s
putty between faucet and sink. Place Deck Plate
over the three holes of sink.
Make sure the O-RING is placed onto the bottom
of Base Ring. Install faucet through Deck Plate.
From underside sink, put Plastic Washer and
Mounting Nut. Position faucet on sink properly
and tighten Mounting Nut.
If necessary, tighten screws using a adjustable
wrench until the faucet is firmly connected to the
sink.
Connect hot and cold water supply lines to the Water
Supply Valves.
2
1
2A
2
2B
3 4