Installation Guide

3
Open the valve, then turn the handle according to the
sign of C and H on the handle to regulate the temperature
of the water. (C=Cold,H=Hot)
Swing Spout
5
6
INSTALLATION PROCEDURES
Remove any debris from valve outlets.
Turning off the water supply valves.
Install without deck plate. Make sure the O-ring
is placed onto the bottom of base ring. Install
faucet through hole in sink, position faucet on sink
properly and tighten the nut from underside of the
sink.
If necessary, tighten screws using a adjustable
wrench until the faucet is firmly connected to the
sink.
water supply valve, and connect hot and cold water lines
Open the water supply valve and flush for about a minute
of the faucet to the water supply valves.
2
1
2A
3
4
Close
Open
After installation is complete, remove spray head and rotate
fter installation is complete, remove aerator and rotate
handle to the closed position. Turn on the water supply
valves, and check all connections for a leak. Turn on
your faucet and allow both hot and cold water to run at
least one minute each, then put the spray head back.
Faucet Start Up
2B
Install with deck plate.
Position deck plate onto sink.
Make sure the O-RING is placed at the bottom of
the faucet base. Install faucet through hole in deck
plate. From underside of sink, attach mounting
assembly. Position faucet on deck plate properly and
tighten Mounting Nut.
to clear the rubbish left in the pipeline, then turn off the