Installation Guide

2
Install the faucet to the hole of sink, and from under the sink,
place Washer and Metal washer and mounting nut onto threaded,
then tighten mounting nut using adjustable wrench.
Insert spray seat through far right-hand hole on sink. Then
tighten mounting nut using adjustable wrench. Insert spray
hose down through spray seat, then Joint is installed in the
end of the pipe, and tighten it using wrench, then as shown in the
figure insert the connector from the body in the middle hole, and
attention to whether to whether the installation in place.
ASSEMBLY AND INSTALLATION INSTRUCTIONS
Fig. 1
Washer
Metal washer
Mounting nut
Sink
Washer
Metal washer
Mounting nut
CAUTION
Always turn off water and relieve pressure before working on your faucet.
PREPARATION
Clean the dirt from valve outlets. Turn off the water supply valves. This is usually found near the water meter.
If you are replacing an existing faucet, remove the faucet from the sink, and clean the sink surface thoroughly.
Estimated Assembly Time: 20 minutes
Helpful Tools: (not included)
PTFE plumber’s tape or thread sealant Flathead screwdriver Phillips screwdriver
Pliers
Adjustable wrench
Cloth
Your installation may require supply lines and/or shut-off valves, cone washers, friction rings, or other additional tools.
Consult the store where your faucet was purchased for connections that may be required for your area.
3
MAINTENANCE AND CARE
After installation is complete, remove aerator and rotate
handle to the closed position. Turn on the water supply
valves, and check all connections for a leak. Turn on your
faucet and allow both hot and cold water to run at least one
minute each, then Install the Aerator.
Connect spout hot water supply line to the left valve connector.
connect Spout cold water supply line to the right valve connector,
and connect hot and cold water supply lines to the water supply
valves, then tighten Supply line nut.
Turn off water and relieve pressure before working on your
f
aucet! Pull out the button at the top of the handle, screw the
screws out with a cross screwdriver, pull out the handle and
unscrew the cover, unscrew cartridge and inspect it, replace
parts as necessary. Reassemble parts by reversing steps.
1. Faucet Start Up
3.
2. Handle and Valve Removal
To maintain the faucet, clean frequently and regularly.
Clean with clear water or mild liquid, rinse with clear water, and then dry with soft cotton cloth.
Do not use any abrasive cleansers, cloths, or paper towels.
Do not use any acid or abrasive detergent.
Fig. 2
Washer
Joint
Push
Faucet
Fig. 3
Cold
Hot
Left
Right