Specification

Installation
Excessive Weight
     

     
INSTALL THE HOOD
Due to excessive weight, two or more person is recommended for this step.
NOTE:
DO NOT INSTALL THIS POWER PACK RANGE HOOD INSERT BEFORE RUNNING A TEST AND
MAKE SURE THE UNIT IS IN GOOD CONDITION. MECHANICAL DAMAGE MIGHT HAVE OC-
CURRED DURING TRANSPORTATION.
1. Remove the decorative panel from the power pack range hood.
2. Cut an openning in the bottom of the cabinet, using the dimensions shown in the table below (ref. to Fig. A).
3. Insert the range hood in the cabinet and secure with the (4) mounting screws from the inner side of the range
hood (Fig. B). Note: Wood blocking might need to be built if it’s not available in order to secure the mounting
screws.
4. Connect the duct and power cord.
5. Replace the decorative panel.
Wood Blocking
Fig. B
Fig. A



Model X Y
NX-E90-30
26"
16 5/8"
NX-E90-36
32 1/2"
16 5/8"
Page 10