ProLam ULTRA 6 Roller Photo Pouch Laminator Professional Grade Operation Manual Make sure you read this manual before using the machine. Store this guide safely, so that you can use it in the future.
Contents 1. Specifications............................................................ 1 2. Safety Precautions................................................. 2-3 3. Lamination Settings Guide....................................... 4 4. Control Layout & Functions..................................... 4 5. Operating Instructions........................................... 5-6 6. Troubleshooting......................................................... 7 7. Warranty Policy........................................
2. Safety Precautions WARNING Do not use broken, aging or self-made electrical wire. Do not bend, twist or tie the electrical wire, to avoid the fire or electric shock. If the power cord is damaged, it must be replaced by the manufacturer or our service agent or a similar qualified technician. Do not use a power outlet outlet that is not in accordance with the rated voltage, to avoid the risk of fire or electric shock. Do not disassemble, modify or repair the machine yourself.
2. Safety Precautions WARNING Keep this machine in a dry and cool place. WORK AREA POUCH FILM OBJECTS Make sure the machine has room in front of and behind the machine for adequate airflow and to allow sufficient space for the laminating pouches to go in and out. This machines has been tested to be 100% compatible with Akiles brand laminating pouches. Using other brands may not achieve the same results.
3. Lamination Settings Guide Film Thickness (mil) Paper 3 Without Carrier With Carrier Temp°C Speed Temp°C Speed Letter (20 lb) 100 - 110 4- 7 120 - 130 4- 5 5 Letter (20 lb) 110 - 120 5- 6 120 - 130 3- 4 7 Letter (20 lb) 115 - 125 5- 6 130 - 140 3- 4 10 Letter (20 lb) 120 - 130 4- 5 140 2- 3 14 Letter (20 lb) 130 - 140 3- 4 140 1- 2 * If using a low temperature film, please decrease temp 15 - 20°C. * To avoid damaging the machine, please use recommended settings. 4.
5. Operating Instructions 1. Plug the included power cord into the back of the machine and into a compatible power outlet. 2. Turn on the power switch behind machine 3. Hot Lamination - Hold the HOT / COLD button for 1 second and the LCD display will turn on. - Hot mode icon will flash. - The initial setting is at 100°C and Speed 6 - When the machine has warmed up to the set temperature, the “READY” icon will show on the dispaly and the machine will beep 3 times. 4.
5. Operating Instructions 6. Shutting Down - Press MEMO and then the STOP button to initiate AUTO SHUTOFF. - Once the roller temperature reaches below 65°C, the machine will beep 5 times and the power will shut off automatically. - (Keep the temperature at 70°C and speed 2 for “STAND BY” mode.) Warning - Do not turn off the Power Switch as soon as you are finished laminating to prevent overheating. Please use the AUTO SHUTOFF feature to prevent overheating.
6.