User guide

NT2 LAN Getting Started
Page 6
1.7.2 Initializing the NAS System on a PC
In order to configure and access the network drive, the NAS system has to be initialized first. To do
so, use the discover tool to locate the device, prepare the hard drives and set up the system.
1. Make sure that at least one hard drive has been installed and the network drive is
connected to the local network.
2. Press and hold the reset button, turn on the power and let go of the reset button about 2
seconds later.
3. Wait for the green system LED to start flashing and then start the discover tool from a
computer that is connected to the same local network as the network drive.
4. It will automatically search for the network drive but if it doesn’t start by itself or didn’t find
the drive the first time, click Refresh to start the search process again.
5. Once the device has been located, select it from the list and then click Initialize NAS
System to start the setup of the system.