User manual

Quattro. User Manual

8

2.1.2. Akiyama ASIO drivers Configuration
At the DJ Software select drivers’ configuration and the
following window will appear.
Set “ASIO Buffer Size”. There is not an optimal buffer size
since this parameter will depend upon many factors. As a rule
of thumb lower the “ASIO Buffer Size” until you can hear
noises and distortion when playing audio. When this happens,
raise a little the “ASIO Buffer Size” until no unwanted sound
appears at the audio. To exit press “OK”.
Next you have to configure the inputs and outputs as
explained in the sound card configuring chapter of the software
to be used.
2.2. Virtual DJ
There is a purpose built Virtual DJ LE for QUATTRO. In case
you have a license for Virtual DJ PRO the software will
automatically identify QUATTRO. We will go through the
different steps to install and configure Virtual DJ LE and PRO
to be controlled by QUATTRO.
Minimum system requirements for Windows:
Intel® Pentium® 4 or AMD Athlon™ XP processor
1024x768 resolution
DirectX compatible soundcard
512 MB de RAM.
50 MB free on the hard drive.
Operating System: Microsoft® Windows XP SP3 or newer.
Minimum system requirements for MAC:
Intel® processor
1024x768 resolution
CoreAudio compatible soundcard
1024MB RAM
50 MB free on the hard drive.
Operating System: Mac X v10.5.x or newer.
2.2.1. Virtual DJ LE installation
We will go through the steps to install Virtual DJ LE.
Note: You must uninstall any Virtual DJ LE you have installed
in your PC before you install the Virtual DJ LE (QUATTRO)
version. There can be only one Virtual DJ LE installed in each
PC.
Windows Installation
Execute the Virtual DJ LE file clicking the icon
install_virtualdj_le_vx.y.z.msi where x.y.z is the software
version. Installation will start with a welcome window as seen
below:
Select “Next” to start installation. Following the license
agreement will show up.
Select the accept box and press “Next”
Type of installation is selectable; we recommend you start with
“Typical”. If in later installation you need to select concrete
units to install you shall use “Custom” option.