Operation Manual

9
inputs
outputs
This product complies with the EMC
and LVD European Directives
VOLUME
LINE/CD TUNER TAPE AUX
L
R
CONNECTIONS CONEXIONES/
dx turntables
dx turntables
english
STEREO MIXER
DOMESTIC AMPLIFIER
english
LINE/CD TAPE AUX
ANY OF THESE THREE INPUT IS SUITABLE
CUALQUIERA DE ESTAS TRES ENTRADAS ES ADECUADA
INPUT SELECTOR
DX-303/DX-505 turntables offer two signal output possibilities,
PHONO and LINE. The output mode will be selected by means of the
selector switch located at the rear side of the turntable.
If PHONO is selected the unit must be connected to a device equipped
with Phono input RIAA. Most likely this will be a stereo mixer as seen at
the draw below.
If LINE is selected the unit can be connected to almost all amplifying
units. Just make sure that you connect it at the Line level input of the
amplifier. This will be labelled as Line, CD, Tape or AUX.
Los giradiscos DX-303 y DX-505 disponen de dos posibles formatos
de señal de salida, PHONO y LÍNEA. Mediante el selector situado
en el panel trasero podremos seleccionar el formato de señal de
salida adecuado.
Al escoger PHONO deberemos conectar el giradiscos a un equipo
dotado de entrada Phono (RIAA). Normalmente este equipo será un
mezclador estéreo como se muestra en el dibujo.
Al escoger el formato LÍNEA podremos conectar el giradiscos a
cualquier amplificador o mezclador. En caso de desear conectar el
giradiscos a un amplificador doméstico deberemos seleccionar una
entrada tipo Línea. Normalmente estas entradas aparecen señaladas
como Línea, CD, Tape o AUX. En el dibujo se muestran los distintos
tipos de conexión que podemos realizar.