Owner's manual

2.500"
63.50 mm
1. Print and cut out template. Be sure to print at full scale.
2. Use the template to mark the hole locations on the bin.
3. Drill holes using a 13/64" or 7/32" drill bit.
Attaching Lid to AkroBins
Assembly Instructions
AkroBin
®
Lid
Akro-Mils, 1293 South Main St., Akron, Ohio 44301 • 800-253-2467 • Fax: [phone] • akro-mils.com • e-mail: [e-mail]
©2013 Akro-Mils/Myers Industries #AKM291 01/13
2.500"
63.50 mm
1. Print and cut out template. Be sure to print at full scale.
2. Use the template to mark the hole locations on the bin.
3. Drill holes using a 13/64" or 7/32" drill bit.
Attaching Lid to AkroBins
DRILL DRIVER
TALADRO
PERCEUSE-VISSEUSE
TOOLS: HERRAMIENTAS: OUTILS:
Instrucciones de ensamblaje
AkroBin
Instructions d’assemblage
AkroBin
Note: Newer bins have lid holes provided and do not require drilling.
Installing lids on bins without holes*
1. Print and cut out template. Be sure to print at full scale.
2. Use the template to mark the hole locations on the bin.
3. Drill holes using a 13/64" or 7/32" drill bit.
*Some bins may have indents near the hole location. Disregard
indents and use provided template.
Use this hole and notch to locate holes
in bin sizes 30210, 30220 and 30224.
Use template to locate and drill 13/64" or 7/32" diameter holes.
Use this hole and notch to locate holes in bin size 30230.
Use this hole and notch to locate holes in bin size 30235.
Check card size after printing.