Product Info

C313W Indoor Monitor Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
65
Parameter Set-up:
 Location: set up the location according to where the alarm sensor is
stalled. You can select among ten location types: “Bedroom”, “Gate”,
“Door” “ Guest room” ,“ Hall” ,“Window”, “ Balcony” ,“Kitchen”, “ Study”
and "Bathroom”.
 Zone Type: set up the alarm sensor types. You can select among four
sensor types: “Infrared”, “Drmagnet”, “Smoke”, “Gas”, “Urgency”.
 Trigger Mode: set sensor trigger mode between “NC” and “NO” according
to your need.
 Status: set the alarm sensor status among three options: “Enable”,
“Disable”,”24H”. Select “Enable” if you want to enable to the alarm,
however you are required to set the alarm again after an alarm is
disarmed. Select “Disable” if you want to disable the alarm and select
“24H” if you want alarm sensor to stay enabled for 24 hours without
needing to set up the alarm manually again after the alarm is disarmed.
To configure the disarm code on device screen Arming. Change the current
password and save it.
To check the zone status on Arming > Zone Status screen.