Product Info
Table Of Contents
- 1.Product Overview
- 2.Change Log
- 3.Model Difference
- 4.Introduction to Configuration Menu
- 5.Access the Device
- 6.Language and Time Setting
- 7.Screen Display Configuration
- 8.Sound and Volume Configuration
- 9.Phone Book Configuration
- 10.Network Setting
- 11.Intercom Call Configuration
- 11.1.IP call & IP Call Configuration
- 11.2.SIP Call &SIP Call Configuration
- 11.3.SIP Account Registration
- 11.4.SIP Server Configuration
- 11.5.Outbound Proxy Server configuration
- 11.6.SIP Call Configuration
- 11.7.Device Local RTP configuration
- 11.8.Data Transmission Type Configuration
- 11.9.Call Setting
- 11.10. Intercom Call Configuration
- 11.11.SIP Hacking Protection
- 11.12.Emergency Call Setting
- 11.13.Multicast Configuration
- 11.14.Call Forwarding Setting
- 12.Intercom Message Setting
- 13.Audio& Video Codec Configuration for SIP Calls
- 14.Security
- 14.1.Monitor and Image
- 14.2.Alarm and Arming Configuration
- 14.2.1.Configure Alarm and Arming on the Device
- 14.2.2.Configure Alarm and Arming on the Web Interface
- 14.2.3.Configure Location-based Alarm on the device scree
- 14.2.4.Configure Location-based Alarm on the Web Interfac
- 14.2.5.Configure Alarm Text
- 14.2.6.Configure Arming mode
- 14.2.7.Alarm Action Configuration
- 14.2.8.Check Alarm Log
- 14.3.Screen Unlock Setting
- 14.4.Client Certificate Setting
- 14.5.Power Output Setting
- 15.Door Access Control Configuration
- 16.Device Integration with Third Party Device
- 17.Firmware Upgrade
- 18. Backup
- 19.Auto-provisioning
- 20.Call Log
- 21.Debug
- 22.Password Modification
- 23.System Reboot&Reset
- 24.Abbreviations
- 25.FAQ
- 26.Contact US
C313W Indoor Monitor Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
67
Zone Type: set up the alarm sensor types. You can select among four
sensor types: “Infrared”, “Drmagnet”, “Smoke”, “Gas”, “Urgency”.
Trigger Mode: set sensor trigger mode between “NC” and “NO” according
to your need.
Status: set the alarm sensor status among three options: “Enable”,
“Disable”,”24H”. Select “Enable” if you want to enable to the alarm,
however you are required to set the alarm again after an alarm is
disarmed. Select “Disable” if you want to disable the alarm and select
“24H” if you want alarm sensor to stay enabled for 24 hours without
needing to set up the alarm manually again after the alarm is disarmed.
14.2.3. Configure Location-based Alarm on the device
screen
Configure the location-based alarm on device screen Arming > Arming mode.