Product Info
Table Of Contents
- 1.Product Overview
- 2.Change Log
- 3.Introduction to Configuration Menu
- 4.Access the Device
- 5.Time and Language Setting
- 6.Network Setting
- 7.Intercom Call Configuration
- 8.Relay Switch Setting
- 9.Door Access Schedule Management
- 10.Door Unlock Configuration
- 10.1.Configure PIN Code for Door Unlock
- 10.2.Configure RF Card for Door Unlock
- 10.3. Configure Door Access Using Configured Files.
- 10.4.Editing the User(s)-specific door access data
- 10.4.1.Unlock by QR Code
- 10.4.2.Unlock by Bluetooth
- 10.4.3.Unlock by HTTP Command on Web Browser
- 10.4.4.Unlock by Exit Button by the Door
- 10.4.5.Unlock by Reception Tab
- 10.4.6.Unlock by DTMF Code
- 10.4.7.Body Temperature Measurement for Door Access(Optio
- 11.Security
- 12.Monitor and Image
- 13.Logs
- 14.Debug
- 15.Firmware Upgrade
- 16.Backup
- 17.Auto-provisioning via Configuration File
- 18.Integration with Third Party Device
- 19.Password Modification
- 20.System Reboot&Reset
- 21.Abbreviations
- 22. Contact Us
E16C Administrator Guide
27
8.Relay Switch Setting
8.1. Relay Switch Setting
You can configure the relay switch(es) and DTMF for the door access on the
web Access Control > Relay > Relay interface.
Parameter Set-up:
Trigger Delay (Sec): set the relay trigger delay timing (Ranging from 1-10
Sec.) For example, if you set the delay time as “5” sec. then the relay will
not triggered until 5 seconds after you press “unlock “ tab.
Hold Delay (Sec): set the relay hold delay timing (Ranging from 1-10 Sec.)
For example, if you set the hold delay time as “ 5” Sec. then the relay will
be delayed for 5 after the door is unlocked.
DTMF Mode: select the number of DTMF digit for the door access control
(Ranging from 1-4 digits ) For example, you can select 1 digit DTMF code
or 2-digit DTMF code etc., according to your need.
1-digt DTMF : set the 1-digt DTMF code within range from ( 0-9 and *,#).
2~4 Digits DTMF: set the DTMF code according to the DMTP Option
setting. For example, you are required to set the 3-digits DTMF code if