Product Info

E16C Administrator Guide
48
Parameter set-up:
 Mode: select either Disabled Mode or Wrist Mode for temperature
measurement according to your need. The device can be installed with
digital forehead temperature detector therefore you can are required to
set the mode properly according to your application.
 Mask Detection: select Enable or Disable to turn on or turn off the mask
detection. When enabled, the device will check if the visitor is wearing a
mask or not while reminding the visitor with the announcement “Please
wear a mask” while visitors wearing mask will be prompted either “Keep
face in the frame” or “Keep wrist close to the sensor” depending on the
mode that is selected. Warning alarm will be triggered when the body
temperature measured is detected higher than the defined normal body
temperature.
 Normal Body Temperature: set the body temperature to the predefined
body temperature as the measuring basis in either Fahrenheit or Celsius.
For example if you set the temperature 37.3 degree Celsius as the normal
temperature, then any body temperature measured higher than 37.3
degree Celsius will be deemed as abnormal temperature, while the
temperature lower than 34 degree Celsius will be deemed as low body
temperature.
 Action to Execute: check the box to enable or disable the SIP/IP Call. If
you want to be notified via SIP/IP call when abnormal temperature and
low temperature is detected.
 SIP/IP Call Number: enter the SIP or IP call for the notification. The field