Product Info
Table Of Contents
- 1.Product Overview
- 2.Change Log
- 3.Model Specification
- 4.Introduction to Configuration Menu
- 5.Access the Device
- 6.Time and Language Setting
- 7.Network Setting
- 8.Intercom Call Configuration
- 9.Phone Book Configuration
- 10.Relay Switch Setting
- 11.Door Access Schedule Management
- 12.Door Unlock Configuration
- 12.1.Configure PIN Code for Door Unlock
- 12.2.Configure RF Card for Door Unlock
- 12.3. Configure Door Access Using Configured Files.
- 12.4.Edit the User(s)-specific door access data
- 12.4.1.Unlock by QR Code
- 12.4.2.Unlock by Bluetooth
- 12.4.4.Unlock by HTTP Command on Web Browser
- 12.4.5.Unlock by Exit Button by the Door
- 12.4.6.Unlock by Reception Tab
- 12.4.7.Body Temperature Measurement for Door Access
- 13.Security
- 14.Monitor and Image
- 15.Logs
- 16.Debug
- 17.Firmware Upgrade
- 18.Backup
- 19.Auto-provisioning
- 20.Integration with Third Party Device
- 21.Password Modification
- 22.System Reboot&Reset
- 23.Abbreviations
- 24.FAQ
- 25. Contact Us
E18C Door Phone Administrator Guide
78
13. Security
13.1.Tamper Alarm Setting
Tamper alarm function serves as a protection against any unauthorized
removal of the devices by triggering off the temper alarm on the device. Path:
Security > Basic > Temper Alarm.
Parameter Set-up:
Enable: tick the check box to enable the temper alarm function. When the
temper alarm goes off , you can press the Disarm tab beside the check
box to clear the alarm.
Key Status: temper alarm will not be triggered unless the key status is
shifted from “Low” to “ High” status.
Note:
Disarm tab will turn gray when the temper alarm is cleared.
The round rubber button at the back of the device must be in
press-down status otherwise the alarm will not be fired.
Note:
The round rubber button at the back of the device must be in
press-down status otherwise the alarm will not be fired.