Product Info

IT88 Series Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
48
Parameter Set-up:
 Location: set up the location according to where the alarm sensor is
installed. You can select among ten location types: “Bedroom”, “Gate”,
“Door” “ Guest room”, “Hall”, “Window”, “Balcony”, “Kitchen”, “Study” and
"Bathroom”.
 Zone Type: set up the alarm sensor types. You can select among five
sensor types: “Infrared”, “Drmagnet”, “Smoke”, “Gas”, “Urgency”.
 Trigger Mode: set sensor trigger mode between “NC” and “NO” according
to your need.
 Status: set the alarm sensor status among three options: “Enable”,
“Disable”, ”24H”. Select “Enable” if you want to enable to the alarm,
however, you are required to set the alarm again after an alarm is
disarmed. Select “Disable” if you want to disable the alarm, and select
“24H” if you want alarm sensor to stay enabled for 24 hours without
needing to set up the alarm manually again after the alarm is disarmed.
13.2.3. Configure Location-based Alarm
Configure the alarm sensor in the same way you do on the web interface.
Parameters set up:
 Location: to select which location the detection device is in, including
Bedroom, Guest room, Hall, Window, Balcony, Kitchen, Study and
Bathroom.