Product Info

Single Tenant Door Phone
AKUVOX SMART INTERCOM www.akuvox.com
47
time after the relay is triggered. If Bistable is selected, relay status will be
reset after the relay is triggered again.
 Trigger Delay (Sec): set the relay trigger delay timing (Ranging from 1-10
Sec.) For example, if you set the delay time as “5” sec. then the relay will
not be triggered until 5 seconds after you press “unlock“ tab.
 Hold Delay (Sec): set the relay hold delay timing (Ranging from 1-10 Sec.)
For example, if you set the hold delay time as “5” Sec. Then the relay will
resume the initial state after maintaining the triggered state for 5s.
 DTMF Mode: select the number of DTMF digits for the door access
control (Ranging from 1-4 digits ) For example, you can select 1 digit
DTMF code or 2-digit DTMF code, etc., according to your need.
 1 Digit DTMF: set the 1-digt DTMF code within range from ( 0-9 and *,#) if
the DTMF Option is set as “1-digit”.
 2~4 Digits DTMF: set the DTMF code according to the DMTP Option
setting. For example, you are required to set the 3-digits DTMF code if
DTMP Option is set as 3-digits.
 Relay Status: relay status is low by default which means normally
closed(NC) If the relay status is high, then it is in Normally Open
status(NO).
 Relay Name: name the relay switch according to your need. For example,
you can name the relay switch according to where the relay switch is
located for convenience.
Note:
 Only the external devices connected to the relay switch need to be
powered by power adapters as relay switch does not supply
power.
