User Guide

R28A/V
Admin Guide
R28 uses DHCP mode by default which will get IP address,
subnet mask, default gateway and DNS server address from
DHCP server automatically.
3.4.3.2.Static IP Mode
At device side, press “*2396#” to enter administrator interface.
Press “3” to enter system setting interface, and press “1” to enter
network setting interface.
Select static IP mode, users need to setup IP address, subnet
mask, default gateway and DNS server address. Press “Dial
key” when finish each step.
In Website, go to Network - Basic.
If select static IP, users should manually setup IP address,
subnet mask, default gateway and DNS server address. The
figure right shows static IP settings.
3.4.3.3.Local RTP
Go to Network - Advanced to configure.
Figure 3.4.3.2 Static IP mode
Figure 3.4.3.3 Local RTP