operation manual

GB
25
Mulching with the mulch kit (optional)
When mulching, the grass cuttings are not collected, but
are left on the lawn. The grass mulch prevents the soil
from drying out, and supplies it with nutrients.
The best results are obtained by cutting back regularly
by about 2 cm. Only young grass with a soft leaf texture
decomposes quickly.
 Grass height before mulching: 8 cm maximum
 Grass height after mulching: 4 cm minimum
Adapt your walking pace to the mulching process,
do not walk too fast.
Inserting the mulch kit
Caution - Risk of injury!
Insert/remove the mulch kit only with the motor
switched off and when the mower blade has come
to a standstill.
1. Remove the grass catcher ( 6).
2. Liftthedeectorplateandinsertthemulchkitinthe
outlet shaft ( 7).
It must lock into place.
If the mulch kit is not locked into position, both the
mulch kit and the mower blade may be damaged.
Removing the mulch kit
1. Liftthedeectorplate.
2. Release the lock on the mulch kit ( 8/1).
3. Pull out the mulch kit ( 8/2).
Mowing with side discharge unit (option)
Important – Danger of injury!
Attach or remove the side discharge unit only
when the motor has been switched off and the
cutting blade is at a standstill.
Fitting the side discharge unit
1. Removethegrasscollectorandtthemulchingkit.
2. Press the release lever on the cover of the side
discharge unit ( 9/1).
3. Open and hold the cover of the side discharge unit
( 9/2).
4. Fit the side discharge tunnel ( 9/3).
5. Slowly close the cover.
The cover secures the side discharge tunnel to
prevent it from falling out.
Removing the side discharge unit
1. Open and hold the cover of the side discharge unit
( 9/2).
2. Remove the side discharge unit and close the cover
( 9/3).
Setting the handle height (optional)
Clamp adjustment
1. Hold the bar and loosen both clamps ( 10).
2. Move the bar to the desired position
3. Lock the clamps.