Manualshelf

User Manual

ManualsBrandsAL-KO ManualsLog SplitterAL-KO LSH 370/4 Electric Log Splitter
21222324252627282930
Table Of Contents
462706_m 27
Product description
out residual current circuit breaker in the mains
connection can result in serious injuries or even
death due to electric shock.
■
Before connecting the appliance, check
whether the mains connection has a residual
current circuit breaker for a maximum leak-
age current of 0.03A.
■
If you cannot be sure that a residual current
circuit breaker is installed: Use an additional
portable residual current device with switched
PE conductor.
■
AC 230V / 50Hz
■
Minimum fusing of the mains connection =
16A
2.6.2 Mains cable
WARNING! Risk of injury from electric
shock. A defective mains cable can result in seri-
ous injuries due to electric shock.
■
Ensure that the mains cable is not damaged
or severed.
■
Use only rubber-sheathed cables of quality
H07RN-F according to VDE 0282 Part 14
with a conductor cross section of at least
2.5mm².
■
The maximum permissible cable length is
10m. A longer cable impairs the motor power
and hence the performance and function of
the log splitter.
■
Mains cable, mains plug and coupling socket
must be undamaged. A defective mains ca-
ble (e.g. with cracks, cuts, crushed or kinked
points in the insulation) must not be used.
■
Repairs to the mains cable, mains plug and
coupling socket may only to be carried out by
qualified electricians.
■
Do not expose plug connectors to moisture.
■
If the mains cable is damaged, immediately
disconnect it from the mains.
2.7 Scope of supply
After unpacking, check that all the parts have
been delivered.
2.7.1 Scope of supply for LSH370/4 (03)
No. Component
1 Base unit
2 Bag with small parts
3 Operating instructions
No. Component
4 Supporting struts (2x)
5 Supporting strut
6 Transport handle
7 Wooden rests (2x)
8 Base plate
9 Transport wheels (2x)
2.7.2 Scope of supply for LSH520/5 (04)
No. Component
1 Base unit
2 Bag with small parts
3 Operating instructions
4 Supporting struts (2x)
5 Supporting strut
6 Wooden rests (2x)
7 Front support legs (2x)
8 Front support foot
9 Rear support legs (2x)
10 Connecting strut
11 Transport wheels (2x)
12 Base plate
2.7.3 Scope of supply of protective cover
(05)
No. Component
1 Large top plate
2 Small top plate
3 Small plate for left
4 Small plate for back
5 Large plate for back
6 Plate for front
7 Connecting plates (2x)
8 Bag with small parts