User's Manual

1. Use as External USB HDD

1.1 Insert Hard Disk

9 Use 2.5” IDE Hard Disk for Laptop(or Notebook) PC.

9 Hard Disk should be “Master”. However, if the Hard Disk supports “Single” mode, you need to try to set

“Single “mode.

② Pull the PCB out. ③ Grip HDD and insert it into

the pins of PCB (be sure to

match the 44 pins)

① Grip the hasp and pull back

the front panel, and then open

the top cover.

④ Screw HDD on PCB by using

the supplied screws.

⑤ Insert the PCB into the case,

and then close the top cover

and front panel.