Warranty

7
Dial Type Voltage Selector
To change to 115 volts:
1. Make sure power is off.
2. Turn the dial counter-clockwise until 115 shows in
the dial window.
3. Attach the power lead wires to the power lead
terminals. Make sure the wires are secure.
4. Attach the ground wire to the green ground screw
5. Reinstall the Motor end cover
To Wire a Two-Speed Motor
Wire the pump as shown in the diagram.
Figure 6 – Voltage set to 230 volts, Dial Type.
Voltage
Change Dial
Ground
Screw
Power Lead
Terminals
Figure 7 – 2-Speed motor wiring diagram.
L
2
=
C
O
M
L
1
=
H
I
A
=
L
O
W
A
L2
L1
Power Supply for
Optional Timer.
Low Speed
High Speed
Circuit
Protector
Remote
SPDT
Switch
Ground (Green)
Common
If using timer, Connect
Timer Motor to Low Speed Only
Minimum switch and timer amp rating must equal Branch Fuse
Rating given in "Recommended Fusing and Wiring Data" table.
230
Volt
Lines
Back of
motor
with
Terminal
Board
4558 0304