Specifications

© 2002 Alamo Group Inc.
Parts Section -55
Triumph Sickle Bar (Archive Book) 10/02
Feb. 2001
to
Replacement Part
S/N SB-Replacement
to
S/N SB-Replacement
HYDRAULIC MOTOR
3500 Series
Replacement Motor
Item Part No Part No. Qty. Description
02977120 ------------ 1
* Motor Only, 2.8 CID (# 0188600 Replacement Motor)
(*Use 02977145 Retrofit Kit w/ items 18 thru 21)
------------ 02977279 1
* Motor Only, 2.2 CID (# 0118600M Replament Motor)
(* Use 02978088 Retrofit Kit w/ items 18 thru 21)
1 02977968 02977968 1 * Retaining Ring
2 02977969 02977969 1 * Ball Bearing
3 02977970 02977970 1 * Retaining Ring
4 02977971 02977971 1 * Retaining Ring
5 02977972 02977973 1 * Washer
6 02977973 02977973 1 * Washer, Back-Up
7 02977974 02977974 1 * Pressure Seal
8 02977975 02977975 1 Housing
9 02977976 02977976 1 Input Shaft
9A 02977981 02977981 1 Key
10 02977977 02977977 1 Drive Shaft
11 02977978 02977978 1 Seal
12 02976884 ------------- 1 Geroler, For 02977120 Motor Only
------------- 02977979 1 Geroler, For 02977279 Motor Only
13 02978098 ------------- 1 End Cap, For 02977120 Motor Only
------------- 02976894 1 End Cap, For 02977279 Motor Only
14 02977980 02977980 7 Bolt, Hex Head
15 02978096 02978096 2 Poppet
16 02976893 02976893 1 Spacer Plate
17 02977967 02977967 1 Seal Kit (Items 1, 2, 3, 4, 5, 6, 7 & 11)
18 00001800 00001800 4 Locknut (in P/N 0188600 & 0118600M) Not Shown
19 02757800 02757800 2 Hyd Adapter Fitting (in P/N 0188600 & 0118600M) Not Shown
20 02977865 02977865 1 Motor Adapter Plate (in P/N 0188600 & 0118600M) Not Shown
21 02977866 02977866 4 Bolt, (in P/N 0188600 & 0118600M) Not Shown
MOTORS SIZE IS 2.2 CID or 2.8 CID
NOTE: These are Replacement Motors and were not used in production, There are 2
different Motors, One had 2.8 CID (Used on D3500 Model) & the other has 2.2 CID (Used
on S3500 Model) , Check which Motor needed before ordering High Lighted Parts above.
The rest of the parts on these two size motora are common Parts & will interchange
between the two Motors, The "D3500 & S3500 was a designation as to which tractor it
was mounted on. * These are replacement motors for earlier style Cutters that hat
Old Gear Type Motors, these cannot be mounted without items 18 thru 21 to adapt
these later style motors to older units