Specifications

Page 1 of 2
DECLARATION OF PERFORMANCE – ALDOP14
in accordance with Annex III of European Directive No. 305/2011
Dish basins, Version 1.1 / 2017
1. Unique identification code of the product-type:
Enamelled basins for installation in a counter top
mounted on the wall or on furniture.
2. Type, batch or serial number or any other
element allowing the identification of the
construction product in accordance with Article
11 Clause 4:
Unique identification (article name and number) is
possible through the sticker on the packaging.
3. Intended use(s) of the construction product as
foreseen by the manufacturer in accordance with
the applicable, harmonised technical
specification:
Washbasins
–
sanitary appliance predominantly
foreseen for washing parts of the upper body,
composed of one or more basins, each having one plug
hole, equipped with or without an overflow and with or
without fittings hole(s).
4. Name, registered trade name or registered trade
mark and contact address of the manufacturer in
accordance with Article 11 Clause 5:
A
lape GmbH
Am Gräbicht 1-9
38644 Goslar
Germany
5. If applicable, name and contact address of
authorised representative entrusted with the
duties in accordance with Article 12 Clause 2:
Not applicable
6. System or systems of assessment and verification
of constancy of performance of the construction
product as set out in Annex V:
System 4
7. In case of the declaration of performance
concerning a construction product covered by a
harmonised standard:
Not applicable
8. In case of the declaration of performance
concerning a construction product for which a
European Technical Assessment has been
issued:
Not applicable
9. Declared performance
Essential characteristics
Performance Harmonised technical specification
Cleanability (CA) Pass EN 14688:2006
Static load resistance (LR) NPD EN 14688:2006
Flow rate of overflow (OF) CL00/ CL25 EN 14688:2006
Durability (DA) Pass EN 14688:2006
10. The performance of the product identified in points 1 and 2 conforms with the declared performance in
point 9. This declaration of performance is issued under the sole responsibility of the manufacturer
identified in point 4.
Signed for and on behalf of the manufacturer by:
Carsten Müller Alape GmbH, Germany
Managing Director Goslar, 31.03.2017