User's Manual

ManualsBrandsAlarm.com ManualsElectronicsZ-Wave adds control capabillities to home automation and security

Rhein Tech Laboratories, Inc. Client: Alarm.com

360 Herndon Parkway Model: ADC-200N-EVD

Suite 1400 Standards: FCC 15.249/IC RSS-210

Herndon, VA 20170 ID’s: YL6-143200N25V4/9111A-143200N25V4

http://www.rheintech.com Report #: 2013120DXX

Page 30 of 39

Appendix M: Manual

Please refer to the following pages.

Summary of content (5 pages)

PAGE 1
Rhein Tech Laboratories, Inc. 360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com Appendix M: Client: Alarm.com Model: ADC-200N-EVD Standards: FCC 15.249/IC RSS-210 ID’s: YL6-143200N25V4/9111A-143200N25V4 Report #: 2013120DXX Manual Please refer to the following pages.
PAGE 2
Building 36 Broadband Gateway | Installation Guide Building 36 Ethernet Gateway INSTALLATION GUIDE Regulatory Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate this equipment. This device complies with Part 15 of the FCC Rules and Industry Canada license-exempt standards.
PAGE 3
Building 36 Broadband Gateway | Installation Guide Replicate Mode ● Blinking - Blink both red and yellow LEDs during replicate mode ● Flashing Simultaneously with Yellow LED - The Z-Wave network is busy communicating ● Solid - Replicate completed successfully, both red and yellow LEDs stay solid for 2 minutes, then Off Adding Z-Wave Devices ** Make sure the Building 36 gateway is connected to AC power when enrolling Z-Wave devices.
PAGE 4
Building 36 Broadband Gateway | Installation Guide 3) Enter the Menu Screen by hitting MENU. Touch the Mate/Link button (looks like a tower) on the left side of the screen. down. Locks IMPORTANT NOTE: If the gateway cannot be taken to within 6 feet of the lock installation location or vice versa, add the lock to the system before you install the lock on the door. (You will need to connect the battery pack to the keypad before attempting to perform these steps.
PAGE 5
Building 36 Broadband Gateway | Installation Guide stronger to the front compared to behind the device). I don’t want the thermostat to be solely battery powered, but a “C” wire does not exist from the HVAC unit. It is possible to link a transformer to the thermostat as a substitute “C-wire”, however every thermostat is different. Please make sure to check the thermostat manual for the correct terminals to attach the transformer wires.