User's Manual

ManualsBrandsAlarm.com ManualsElectronicsIntegrated modular communicator for security panels

ADC-620T Module| Installation Guide

- - - SN

Module serial number. Needed to create

or troubleshoot an Alarm.com account.

- - - SIM card

SIM card number. Sometimes needed to

troubleshoot an account.

- - - Version

ADC-620T Module firmware version and

sub-version. Example: 181a, 181 = module

firmware version, a = subversion.

- - - Advanced - Network

For Alarm.com use only.

- - Z-Wave Setup

This menu is used to add, remove, and

troubleshoot Z-Wave devices and

networks. To control Z-Wave devices via

the Alarm.com website and smart phone

apps, you will also need to enable Z-Wave

services on the account.

- - - Number of Z-Wave

Devices

The total number of Z-Wave devices

currently known to the ADC-620T Module.

- - - Add Z-Wave Device

Press [*] to enter Z-Wave Add Mode.

Make sure the device you are trying to add

is powered up and within 3 to 6 feet of the

Neo panel. Refer to the manufacturer’s

instructions for button presses required to

enroll device.

- - - Remove Z-Wave Device

Press [*] to remove an existing Z-Wave

device, or to “reset” a Z-Wave device that

was previously learned into a different Z-

Wave network. Previously enrolled

devices must be reset before they can be

enrolled into the module.

- - - Z-Wave Home ID

Press [*] to query the Z-Wave network

Home ID. If the ID is 0, verify that the

module has communicated with

Alarm.com and that the Alarm.com

account is set up for Z-Wave.

- - Image Sensor Setup

An Image Sensor daughterboard is

required to enable Image Sensor

capabilities on the module. This menu is

only active if an Image Sensor

daughterboard is connected.

- - - Learn Image Sensor

Press [*] to enter Add Mode. Enroll the

Image Sensor by inserting batteries or

resetting.

- - - Delete Image Sensor

Press [*] and scroll to the Image Sensor to

delete. Press [*] to delete.

- - - Image Sensor Settings

Press [*] and scroll to the Image Sensor of

interest. Press [*].

- - - - Image Sensor #[x]

[x] is the sensor ID. Press [*] to view

information on this Image Sensor.

- - - - - [Power Information]

Gives information on the Image Sensor’s

battery level and power status.

- - - - - Signal

The signal strength of the communication

between the Image Sensor and the Image

Sensor daughterboard.

- - - - - Test PIR

Press [*] to put the Image Sensor in PIR

Test Mode.

- - - - - PIR Sensitivity

Press [*] to view current selection. Scroll

down to view available sensitivity levels.

Press [*] to select.

- - - - - Rules

Displays whether rules are confirmed.

- - - - - MAC

MAC address of Image Sensor.

- - - - - Version

Image Sensor daughterboard version.

- - - - - Last Talk

Lask Image Sensor talk time.

- - - Extended Range Option

Press [*] to enable/disable extended

range.

- - Communications Test

Press [*] to perform ADC communication

test.

User Functions

Press [*] [6] [Master Access Code] to

enter User Functions menu. Then scroll

right to “Interactive Serv” and press [*] to

enter Interactive Services menu.

- - Module Status