User's Manual

ManualsBrandsAlarm.com ManualsElectronicsMotion Sensor which Generates images of the Motion

Rhein Tech Laboratories, Inc. Client: Alarm.com

360 Herndon Parkway Model: ADC-IS-221-LP

Suite 1400 Standards: FCC 15.247/IC RSS-210

Herndon, VA 20170 ID’s: YL6-143IS221/9111A-143IS221

http://www.rheintech.com Report #: 2015133

Page 42 of 49

Appendix K: Manual

Please refer to the following pages.

Summary of content (6 pages)

PAGE 1
Rhein Tech Laboratories, Inc. 360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com Appendix K: Client: Alarm.com Model: ADC-IS-221-LP Standards: FCC 15.247/IC RSS-210 ID’s: YL6-143IS221/9111A-143IS221 Report #: 2015133 Manual Please refer to the following pages.
PAGE 2
Interlogix part number: 600-9400-IMAG Alarm.com part number: ADC-IS-221-LP Alarm.com Image Sensor Installation Guide 3. Install Alarm.com Module Inside Control Panel 4. FOR SIMON XT ONLY, Connect Daughterboard Alarm Wire - On the XTi panel, the blue alarm hardwire is not required and should not be connected. For XTi panels, skip to step 5.
PAGE 3
Alarm.com Image Sensor Installation Guide Simon XTi - To enroll the sensor on a Simon XTi, follow these steps at the control panel: a. Begin with the batteries removed from the sensor. b. On the panel, scroll until the screen shows “Programming” and press “Enter”. c. Enter the installer code (default 4-3-2-1), and press OK. d. Press “Interactive Services”. e. Press “Image Sensor”. f. Press “Add”. The screen will display “Reset or power-up sensor to enroll…” g. Insert the batteries into the sensor.
PAGE 4
Alarm.com Image Sensor Installation Guide (Note: Using the high sensitivity profile increases the risk of false alarms, especially if the sensor is facing windows or sources of heat. When mounting the sensor near windows or heat sources use caution and select the “Low” PIR sensitivity setting.) 40 ft B. PIR Activation and Test Mode 20 ft During normal operation, the PIR can be activated at most once every three minutes while the system is disarmed.
PAGE 5
Alarm.com Image Sensor Installation Guide also issued via the Alarm.com platform if the customer has subscribed to this notification type. (Note: Low battery messages are only active at the panel between 7:00am and 10:00pm.) To replace the sensor batteries, slide the front of the sensor up off the sensor-back. (No need to remove or un-mount entire sensor-back and mounting arm.) To maximize battery life, replace the sensor batteries with 2 AA 1.5v Energizer Ultimate Lithium batteries.
PAGE 6
Alarm.com Image Sensor Installation Guide Recommended Mounting Height: 8 ft Recommended Mounting Angle: 6° for large coverage area and rooms greater than 30 ft (“teeth up” on mounting arm); 18° for rooms less than 30 ft (“teeth down” on mounting arm) Motion Profiles & Sensor Range: Normal (up to 30 ft, default), High (up to 35 ft), Low (up to 25 ft) REGULATORY INFORMATION Changes or modifications not expressly approved by Alarm.com can void the user’s authority to operate the equipment.