Rhein Tech Laboratories, Inc. 360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com Appendix K: Client: Alarm.com Model: ADC-NK-100T Standards: FCC 15.247/IC RSS-247 ID’s: YL6143NK100T/9111A-143NK100T Report #: 2015014DTS Manual Please refer to the following pages.
Alarm.
Alarm.com Hub Install Guide | 3 Box Contents: Alarm.com Hub (Cellular Version) Power Cable/ AC Adapter What You Need: Customer Account If you don’t already have a customer account with us, visit www.Alarm.com, and click on “Get Started” to find an authorized Alarm.com dealer near you.
| Alarm.com Hub Install Guide Alarm.com Hub Install Guide | 5 Alarm.com Hub Overview Installation Step 1: Powering Up the Hub With the Alarm.com Hub as your home’s command center, you’ll gain remote control of your key devices using our reliable and secure cloud service. Create automated lighting, thermostat and video recording rules, and get customized alerts to always know what’s going on at home. • Plug the AC adapter into an unswitched outlet.
6 | Alarm.com Hub Install Guide Unpairing Z-Wave Devices (If all Z-Wave devices were added successfully, skip to Step 3 below) • To put the Hub in Unpairing Mode, press and hold the Pairing button ( ) for five seconds until the Status Light flashes orange slowly and the Hub beeps twice. • To put your Z-Wave device into Unpairing Mode, follow the instructions that came with the device. For many Z-Wave devices the same button is used for pairing and unpairing.
8 | Alarm.com Hub Install Guide Alarm.com Hub Install Guide | 9 Advanced Mode This section is for authorized professional installers and service providers. The Hub has an Advanced Mode for troubleshooting and service. To access features in the following section, put the Hub in Advanced Mode by holding down the Pairing button ( ) for 10 seconds. When the Hub enters Advanced Mode, it will beep three times, and the Status Light will alternate colors.
10 | Alarm.com Hub Install Guide Alarm.com Hub Install Guide | 11 Status Light Definitions User Mode Cellular Hub LIGHT COLOR WHITE LIGHT PATTERN/BEEPS MEANING Solid Hub powered on and connected to Alarm.com Fast blink No cellular signal strength. Hub not connected to Alarm.com One blink Signal strength inadequate (1 out of 6 bars). Hub not connected to Alarm.com Two blinks Minimum recommended signal strength (2 out of 6 bars). Hub not connected to Alarm.
12 | Alarm.com Hub Install Guide Alarm.com Hub Install Guide | 13 Status Light Definitions (Continues) Advanced Mode Cellular Hub LIGHT COLOR WHITE GREEN LIGHT PATTERN/BEEPS MEANING Solid No errors or status messages One blink No Z-Wave nodes Two blinks SIM card missing Three blinks Trying to register with HSPA/CDMA network Four blinks Connected to HSPA/CDMA network. Cannot connect to Alarm.
14 | Alarm.com Hub Install Guide Regulatory & Certifications Hub Specifications Power Requirements 5V nominal Standby current 90mA (45mA in PowerSave Mode) Peak Current 1.5 A Max. Voltage Protection 28V Operating Voltage 4.6V - 5.53V Operating Temperature 32 to 120°F (0 to 49°C) Storage Temperature -30 to 140°F (-34 to 60°C) Max. Relative Humidity 90% non-condensing Module Dimensions 13.75 cm x 14.
16 | Alarm.com Hub Install Guide Copyright © 2015 Alarm.com. All rights reserved. Alarm.com and the Alarm.com Logo are registered trademarks of Alarm.com.
