080p Indoor Wi-Fi Camera Installation Guide ADC-V515
Pre-installation checklist • ADC-V515 camera (included) • AC power adapter (included) • 2.4 GHz Wi-Fi connection to broadband internet (Cable, DSL, or Fiber Optic) • An Alarm.com account with a service package that supports video • A computer, tablet, or smartphone with Wi-Fi is required if the router does not have the Wi-Fi Protected Setup (WPS) feature There are two options for connecting the ADC-V515 to the Internet: Access Point (AP) mode and Wi-Fi Protected Setup (WPS) mode.
In the box • • • • • ADC-V515 camera Mounting bracket Power adapter Installation guide Wall anchors & screws (x2) (use 3/16" or 5 mm drill bit) Overview ❶ Camera lens ❷ Infrared light ❸ Status light ❹ Ambient light sensor ❺ Microphone ❶ DC power connector ❷ Friction ball joint ❸ Friction hinge joint ❹ Base ❺ Reset / WPS button ❶ Rubber pad ❷ Mounting recess ❸ Speaker ❹ Micro SD card slot 2 ❹ ❺ ❶ ❷ ❸ ❶ ❷ ❸ ❹ ❺ ❶ ❷ ❸ ❹
Installation Choose the appropriate installation wizard (customer or technician) below or proceed to the AP mode or WPS mode section to begin adding the camera. Customer - Mobile App Installation Wizard ❶ Log in to the Mobile App. You will need the username and password of the account to log in. ❷ Tap the navigation menu. ❸ Tap + Add Device > Video Camera > ADC-V515. (If you do not see the Add Device option, please use the AP mode or WPS mode instructions below to complete your installation.
❸ On an Internet enabled device, connect to the Wi-Fi network ADC-V515 (XX:XX:XX) where XX:XX:XX is the last six characters of the ADC-V515’s MAC address, which is located on the camera or on the packaging. ❹ On the same device, open a web browser and enter http://v515install in the URL field. Follow the on-screen instructions to add the ADC-V515 to the Wi-Fi network. The LED will be solid green when the connection is complete.
❺ Select the camera from the video device list or type in its MAC address to begin adding the camera. The camera’s MAC address is located on the camera or on the packaging. ❻ Follow the on-screen instructions to finish adding the camera. You can now power down the camera and install it in its final location using the included hardware. You may configure camera settings from the Customer Website. Status light guide Off - Power off Solid green - Connected to Alarm.
Troubleshooting • If you have issues connecting the camera to the account, power cycle the camera and try again. • If issues persist, press and hold the Reset button located on the bottom of the camera until the LED is blinking green and red (about 15 seconds), then release the button. The camera will reboot with factory default settings. If the camera was previously installed to an Alarm.com account, it will need to be deleted before it can be installed again. Questions? Visit answers.alarm.
Notes
8281 Greensboro Drive Suite 100 Tysons, VA 22102 200630 © 2020 Alarm.com. All rights reserved.