User's Manual
6
18 Battery Switch
Switch to βONβ for the battery to be charged when AC power is connected and serve as a
backup power source when AC power is missing.
19 Built-in Power Unit Connector
20 Zone Terminal & 12V Auxiliary Voltage Output Terminal & GND Terminal
Zone 1-16 Hardwired Input Zones.
21 4G-LTE External Antenna Terminal
For connecting external antenna to the panel.
ο Do not disconnect the internal antenna when connecting the external antenna.
To switch between the use of internal or external antenna, please configure
through software setting. See chapter 7.1, GSM for details.
22 Internal Antenna PCBA
23 Learn Button
To be used for local learning or local reset.
24 Tamper
25 USB Port (optional)
When connecting a USB dongle into the port, it is suggested to use a USB extension cable.
There is no USB Port for the panel if it is built in 4G and Wi-Fi.
26 Micro-SIM Card Socket (not hot swappable)
27 Ethernet Port
28 Room for SLA Battery Pack
Room for installing 12V 7A rechargeable battery pack.
29 J53 Jumper Switch
J53 Jumper Switch can be served as a terminating resistor, which can be turned to ON
when wiring different devices to the panel to enhance connection.
30 U-shaped Grommet x 4
To be used to replace the Removable Protective Cover to enhance wiring and cord
management flexibility. Ensure to save the Protective Cover removed for future use.
31 Tube Fuse
250Vac 2A fuse for circuit protection.
32 Velcro Tape x 4 (loop side)
To be applied on the battery pack for easy battery installation and connection.
33 In-line Tube Fuse Holder