User's Manual

28
5. Device Management
The Device Management section allows you to learn in, edit, control and view all available
accessory devices that can be included in the Panel.
5.1. Learning of Devices
Use this function to add new devices into the Control Panel.
The following types of accessory devices are supported:
 RF device: All Climax RF devices are supported. (For ZigBee only model, RF devices are
not supported.)
 ZigBee device: All ZigBee device with ZigBee Home Automation 1.2 profile are supported.
<IMPORTANT NOTE>
 The Control Panel built-in ZigBee module supports up to 40 ZigBee devices by itself. If
you wish to include more than 40 ZigBee devices into the Control Panel, you must add
extra ZigBee Routers into the Control Panel’s ZigBee network to increase the network’s
maximum device capacity.
 IP Cameras: The Control Panel is compatible with Climax VST-1818 Series IP Camera. Up
to 6 IP Cameras are supported.
5.1.1. Add Sensor
Step 1. Click on “Learning” to enter learn page.
Step 2. Click on “Start” to enter learning mode.
Step 3. Press the test or learn button on the each device or any button on the Remote
Controller. (Please refer to each sensor’s user manual for test or learn button position).
<NOTE>
 For ZigBee sensors, press and hold the learn button for 10~12 seconds to transmit a
learn code.
 For IP Camera VST-1818 Series, press and hold the Privacy button for 10 seconds.
Step 4. When the system received the signal transmitted from device, the screen will display its
information for selection.