User's Manual

<NOTE>

 It takes 5-10 seconds for the Control Panel to receive a learn code from ZigBee or

Shutter Control Sensor.

Step 5. Click “Add” to include selected device into panel. If the sensor you wish to learn into

already exists in the system, the sensor information will be displayed in the Learned

Device section. If not, the sensor information will be displayed in the Detected Device

section.

<NOTE>

 For VST-862 F1 devices, press and hold the learn button for 3 seconds for the Control

Panel to receive a learn code, and then click “Add” within 30 seconds.

Step 6. If the device is successfully learnt into the system, the added device will be displayed in

the “Learned Device” section.

Step 7. Repeat Step 3~5 to learn in all device, click Stop to exit learn mode when complete.

The system will automatically exit Learn mode if left idle for 5 minutes.

5.1.2. Local Learning

Instead of learning devices via configuration webpage, you can also learn in devices by using

the learn button of the Control Panel.

Step 1. Press and hold the learn button of the Control Panel for 10 seconds, release when the

Control Panel emits one short beep. LED 1 & 2 (Green) will turn ON to indicate the

Control Panel is now in learning mode.