User's Manual

Step 2. Press the test or learn button on each device to transmit signal, refer to device manual

for detail.

Step 3. When the Control Panel receives signal from device, it will emit 2 beeps to confirm. The

device will be included in the panel automatically.

Step 4. After finishing learning all devices, press the button once. The Control Panel will emit 2

short beeps to indicate it has returned to normal operation mode. LED 1 & 2 will dim. If

the user does not press the button within 5-6 minutes, the system will automatically

return to normal operation mode.

<NOTE>

 The Control Panel cannot enter learning mode when under Away Arm/Home Arm or

Walk Test mode. The Control Panel will emit 5 beeps to indicate error.

5.1.3. Edit Devices

After finish learning devices, proceed to edit the device setting.

Step 1. Click Panel to enter Panel webpage. All learnt in devices will be displayed under

Device List section.

Step 2. To edit the device setting or information, click “Edit” at end of device entry.

Step 3. You will enter Device Edit webpage