User's Manual

5.2. ONVIF IP Camera Discovery

You can learn-in the ONVIF IP Camera into you alarm system by connecting the IP Camera to

the same local LAN of the Control Panel.

<NOTE>

 This function is only available for integrating specific ONVIF IP Cameras.

 The server and the platform of the camera must support this function.

 See Dahua and Hikvision Learn-in Setting Quick Guide for detailed information.

Step 1. Connect IP Camera to the same LAN of Control Panel.

Step 2. Make sure the panel is properly installed, and open its webpage, and click on “ONVIF

IPCam Discovery” under Device Management.

Step 3. Set the Control Panel into learning mode.

Step 4. Enter the Camera’s User ID and Password under the Detected Device section.

• UserID: admin

• Password is printed on the label attached to the camera’s box.

Step 5. Once the learning is successful, the information will be shown in Learned Device.