User's Manual

5.13. Wired Zones Programming

5.13.1. 16 On-board Zones and Zone Expanders (WEZC-8, WEZ Series)

Step 1. Click on “Wired Sensors” to enter this page. The 16 on-board zone setting page is

displayed as below.

Step 2. If an expander module (WEC-8 or WEZ series) is added, you will see Expanders at the

bottom of the page. Click “Edit” at the end of the expander’s entry to access wire zone

programming.

Step 3. Edit the type of the wired sensor, zone wiring, and the EOL resistance for each zone.

 Type: Select the type of the wired sensor for each zone from the drop down menu.

 Loop: Select the number of loop corresponding to the zone wiring for each zone from the

drop down menu. On this web page, there are wiring diagrams below for your reference.

Please refer to 3.3 Hardwire Installation – Zone Wiring for zone wiring instructions.