User's Manual

53
Step 5. If the process is successful, the screen will display “Updated Successfully.” The
sensor will be assigned to specific area and zone. To edit the device setting or
information, click “Edit” at the end of device entry.
Step 6. You will enter Device Edit webpage.
Step 7. Edit your device setting and information according to instruction below. Click “OK” to
save changes when finished. Alternatively, click “Default” to reset all parameters to
default values or click “Reset” to re-enter all the information.
 Name: Enter a name for the device.
 Area: Select the area which the device belongs to.
 Zone: Select the Device zone number.
 Attribute List:
The attribute list determines panel behavior when the panel receives trigger signal from
the device. There are
General Attribute:
 Permanentlyt Bypass
This function allows user to permanently deactivate (bypass) the selected device.
 If bypassed, then the Control Panel will not respond at all when the sensor is
triggered.
 If bypassed, the system can be armed directly regardless the device’s fault