User's Manual

56
 A sensor set to 24HR attribute will ignore Disarm, Full Arm, Home are and Exit
response setting. The panel will activate selected alarm when this sensor is
triggered regardless of system mode under any time.
<NOTE>
 Some devices have their own unique functions and will have its own attribute setting which is
not listed in this section. Please refer to the device manual for its setting detail.
Step 7. If you want to delete the sensor, refer to step 2 and select “Disabled” from the drop
down menu of Type to delete it. If the process is successful, the screen will display
“Updated Successfully.”
5.13.2. Output Expander (WEPC-1)
Step 1. Click on “Wired Sensors” to enter this webpage.
Step 2. If an expander module (WEPC-1) is added, you will see “WEP” in the Expanders
section at the bottom of the page. Click “Edit” at the end of the expander’s entry to
access wire zone programming.
Step 3. Select and assign the output switch for each zone.
 Type: Select to activate the power switch for each zone from the Type drown down menu.
The default setting is “Disabled” and you can choose to assign the dry contact relay output
power switch to a zone by selecting “Power Switch”.