Users Manual

and enter Home Arm mode when the timer expires. The user must leave area protected

by sensors before the timer expires, otherwise an alarm will be activated with the

sensor is triggered (Default as 10 seconds).

 Alarm Length: Set the duration the external siren should sound when an alarm is

activated.

 Cross Zone Timer: Please refer to 10.3 Cross Zone Timer for details

 Fire Verification Time: Please refer to 10.4 Fire Verification Timer below for details.

Sound Setting

 Door Chime Setting: this function is available only when the attribute of Door Contact

(DC) and/or PIR detector (IR) is set as Door Chime.

The Control Panel sounds a Door Chime (Ding-Dong Sound) while the DC and/or IR is

activated in Disarm / Full / Home / Entry mode.

 Entry Delay Sound for Full Arm: this is for you to decide whether the Control Panel

sounds count-down beeps and volume of beep during the entry delay time in the full

arm mode.

 Exit Delay Sound for Full Arm: this is for you to decide whether the Control Panel

sounds count-down beeps and volume of beep during the exit delay timer in the full arm

mode.

 Entry Delay Sound for Home Arm: this is for you to decide whether the Control Panel

sounds count-down beeps and volume of beep during the entry delay time in the home

arm mode.

 Exit Delay Sound for Home Arm: this is for you to decide whether the Control Panel

sounds count-down beeps and volume of beep during the exit delay timer in the home

arm mode.

 Confirm Sound: this is for you to decide whether to turn off/or adjust Control Panel

beeping sounds when changing Arm/Home Arm/Disarm mode.

 Warning beep: this is for you to decide whether the Control Panel will sound a warning

beep whenever a fault condition has been detected and displayed. The warning beep

will be silenced after the Fault message has been read by the user. When a new fault

condition is detected, it will then again emit a warning beep every 30 sec.

 Entry/ Exit Only Final Beeps: This is for you to determine when the Control Panel

should start warning beep during Entry or Exit countdown timer. For example, if the

setting is set to 5 seconds, the Control Panel will only stat warning beep during the last

5 seconds of Entry or Exit countdown timer. When set to Disable, the Control Panel will

sound warning beep during the entire Entry or Exit countdown timer.