Users Manual

66
6.3. PIN Code
The User PIN Codes are used by Remote Keypad accessory to control system mode remotely.
You may set up the PIN Codes available for the areas in the control panel. Each consists of 4-6
digits (numeric number 0~9), no disallowed PIN code. User PIN code #1 for each Area is always
activated factory default.
User PIN #1 in Area 1 User PIN #1 in Area 2
Password: 1234 Password: 4321
Area
Area: Select the area for setting User PIN Code.
User Code Setting
 User Code: Enter the 4-digit code in the field.
 User Name: Enter a user name for easy recognition of system events. Up to 17
alphanumerical characters are allow for each user name.
 Latch:
Latch  Latch Report ON = Whenever the User PIN Code is used to change
system mode, the panel will report the event.
Latch  Latch Report OFF = When the User PIN Code is used to change system
mode, the panel will not report the event.
 Delete: Check the box if you want to delete selected user. User#1 in each area cannot
be deleted
After finish all setting, click OK to confirm change.