Quick Start Guide

Connect the camera to the Wi-Fi network using AP mode or WPS mode:
AP mode
1. The camera’s LED will blink white after the
boot up process.
If the LED is not white after two minutes, hold
down the doorbell button and release when
the LED begins to blink white (about 45
seconds).
2. On an Internet-enabled device, connect to
the Wi-Fi network “ADC-VDB770 (XX:XX:XX)”
where XX:XX:XX is the last six characters of
the MAC address, which is located on the
packaging.
3. On the same device, open a web browser
and enter “http://vdb770install” in the URL
field. Follow the on-screen instructions to add
the ADC-VDB770 to the Wi-Fi network. The
camera's LED will be solid green when the
connection is complete.
WPS mode
1. After the boot up process is complete (the
camera’s LED will be blinking white), hold down
the doorbell button and release when the LED
begins to blink blue (about 30 seconds).
2. Activate WPS Mode on the router. The
router will begin to connect to the Wi-Fi
network. The camera’s LED will be solid green
when the connection is complete.
3. Add to Account
Add the camera to the account using one of these methods:
• Selecting the account in MobileTech
• Using a web browser to navigate to www.alarm.com/addcamera
• Adding the device in the customer mobile app