Quick Start Guide

LED Reference Guide
LED Status
Description
Status LED
•
Off
Power off
••••
Blinking Red
Power on, camera booting
••••
Blinking Green
Local network connection
•
Solid Green
Connected to Alarm.com
••••
Blinking Blue
WPS mode
••••
Blinking White
AP mode
Trouble Condition
•
Solid Red
No local or Internet connection.
See Troubleshooting section.
Power Cycle
••••
Blinking Yellow
Camera power cycling
Factory Reset
••••
Alternating Red and Green
Camera resetting to factory default
Troubleshooting
• If you have issues connecting the camera to the account, press and hold the doorbell
button until the LED blinks yellow (about 60 seconds), then release the button. The
camera will power cycle.
• If the issue persists, press and hold the doorbell button for until the LED blinks
alternating red and green (about 75 seconds), then release the button. The camera will
reboot with factory defaults. If the camera was previously installed to an Alarm.com
account, it must be deleted before it can be installed again.
Questions?
Visit: alarm.com/doorbell or answers.alarm.com