User's Manual

WM2020CU
User Manual
TYPE OF PRODUCT
WLAN/BT MODULE
CONFIDENTIAL
13
Compliance Information
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to the radio communications. However, there are no guarantees
that interference will not occur in a particular installation.
Troubleshooting
If this equipment does cause harmful interference to radio reception, which can be determined
by turning the equipment off and on, the user is encouraged to correct the interference by one or
more of the following instructions.
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Consult dealer or an experienced radio technician.
Conditions
Operation is subject to the following conditions
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause
undesired operation.
FCC Caution
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause har
mful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the authority to operate equipment.
This equipment must be installed and operated in accordance with provided instructions and the
antenna(s) used for this transmitter must be installed to provide a se
paration distance of at least
20 cm from all persons and must not be co-located or operating in conjunction with any other
antenna or transmitter. End-users and installers must be provide with antenna installation
instructions and consider removing the no-collocation statement.