Specifications

Eagle Research Corporation

REV 11.1.11 Page | 29

Viewing Parameters

In configuration mode, any parameter value may be viewed. One method is to use the

Jump key to directly view database items. Press Jump and then enter the address of

the parameter followed by pressing the ent key. The top line on the display is the

software address, and the bottom line is the value. Function key assignments are still

valid, so often-viewed parameters may be accessed in this manner. The right and left

arrow keys  ) allow horizontal movement between processes, and the up and

down arrow keys allow moving vertically within a process. Pressing Jump

followed by the right arrow key ( will display the same item number in the next

section. Likewise, pressing Jump followed by the up arrow key will display the

same item number in the previous section. Jumping to assigned labels is also

supported as described in Display Mode.

Editing Parameters

1. Enter configuration mode by pressing the conf key (use the password if required).

2. Display the desired parameter. Press the jump key, followed by the address of the

parameter. The function keys can also be used to view assigned parameters.

3. With the desired parameter displayed, press the edit key. (The unit will display the

current parameter value and prompt for a new value.) Use the keypad to enter the

correct value and then press the ent key to execute the change. Pressing the esc

key when the RTU prompts for the new value will abort the change. Pressing the

ent key if nothing has been typed, also leaves the parameter unchanged.

Assigning Function Keys

In configuration mode, any item can be assigned to a function key as follows:

1. Enter configuration mode by pressing the conf key (use the password, if required).

2. Display the desired parameter. Press the jump key, followed by the address of the

parameter.

3. Assign a function key to the parameter. Press the jump key, the edit key, and then

the function key you wish to assign to the current item [F0 - F9].

Audit Trail

The RTU maintains an electronic audit trail file that records all parameter changes and

calibrations performed on the unit. Each entry is identified with the date and time the

event occurred. The contents of this file cannot be changed, providing a secure, non-