Programming instructions

15
Lock Defaults for PDL6100
Users added will default to a Group Association and a Programming Level ability as follows:
USER TYPE USER NUMBER
GROUP DEFAULT
ASSOCIATION
MINIMUM PROGRAM
LEVEL (See page 6)
Master Code 1 - M
Installer Codes 2 & 3 none 4
Manager Codes 4 - 6 none 3
Supervisor Codes 7 - 9 none 2
(Reserved) 10 - 11 none --
Basic User Codes 12 - 50 none none
Basic User Codes Group 1 51 - 100 1 none
Basic User Codes Group 2 101 - 150 2 none
Basic User Codes Group 3 151 - 200 3 none
Basic User Codes Group 4 201 - 250 4 none
Basic User Codes 251 - 296 none none
Quick Enable User 300 Code 297 none none
(Reserved--see page 7) 298 none none
Guard Tour Code* 299 none none
Service Code 300 none none
Basic User Codes 301-5000 none none
*This code is a Non-Pass code and therefore does not allow passage through the door.
1. New Master Code (User Number 1)
; 1 ; [ _ _ _ _ _ _ ] ; [ _ _ _ _ _ _ ] :
(New Master Code) (Confirm New Master Code)
2. Adding and Deleting User Codes and/or Proximity
Cards (for User Numbers 2-5000)
; 2 ; [ _ _ _ _ ] ; [ _ _ _ _ _ _ ] :
(User Number) (User Code)
• Master Code must be 6 digits-only.
• Master Code is Keypad Code Access only.
• Factory Default = 123456
• See "Lock Design Overview" on page 5 for more information about Master Codes.
M
USERS
Programming Functions
• User Number must be between 2 and 5000.
• User Code must be 3-6 digits.
• Each User Code can be thought of as a person. As long as each person possesses their own
unique User Code, you can control access to the lock by adding or deleting User Codes. See
"Terminology Used in this Manual" on page 6 for more information.
3
(Deleting Entire User)
; 2 ; [ _ _ _ _ ] : [Beep Beep Beep]
(Wait 10 seconds for
beeping to end)
(User Number)
(Entering a Proximity Card)
; 2 ; [ _ _ _ _ ] : [Beep Beep Beep]
(Present card to reader
within 10 seconds)
(User Number)
(Entering a "User Code" / "PIN No. Code" into the lock programming)